part of a route electrified

 
  K163 Chief Commissioner

Location: Well you see that house over there? Well it's not that one.
hi all, is it possible to have a route part electrified? e.g. as if there is a tourist railway that runs onto a suburban line?

Sponsored advertisement

  gallop3 Deputy Commissioner

hi
check
chris trains out
apparently they have shapes and textures for fake catenary
i think i read about it from train_sim.com forun
cheers
ian LaughingLaughing
  K163 Chief Commissioner

Location: Well you see that house over there? Well it's not that one.
no, thats not what i men,t i mean with real wires, line at place like Frankston, where the electris trains terminate, and only diesel and steam trains take can go thurther
  michaelgreenhill Administrator That's Numberwang!

Location: Melbourne
It is not possible to have only a section of a route electrified, but you can set the wire height to 100000ft and have fake catenery and wires on the electrified bit, thats at least passable
  chuffbuff29 Locomotive Driver

What about electrified track instead of wires above, i guess that also implies it's not possible on a part tourist & suburban line? EmbarassedRolling Eyes
  trainfreak Site Admin

lol I do remember reading a post on ts.com about it... are you planning on doing the Healesville line by any chance?
  Comeng 315M Assistant Commissioner

lol I do remember reading a post on ts.com about it... are you planning on doing the Healesville line by any chance?
"trainfreak1000"


hey

the route that im making for msts, of the vic scene, PTC related actaully may have something to do with that line.... maybe near lilydale. but we have to work out this issue because where my line starts its electrified, however i would like to extend it backwards...... so i dont have much time to research this so if someone could work it out would be greatly appreciated. contact me at p_dacey@hotmail.com directly. Obviously you will be aprt of the construction of this route, 4 stations completed, minus the station signs, need someone to help here...
  g523 Train Controller

Location: rowville
how do u make names for places and sidings? i cant put platforms in becuase it always says it to far away from the track!!  and everytime i want to put a signal or crossing in it comes up with japanese stuff!!!!!!!!!

Sponsored advertisement

Subscribers: Comeng 315M, g523, trainfreak

Display from:   

Quick Reply

We've disabled Quick Reply for this thread as it was last updated more than six months ago.