A New Smokebox Door Seal For 6A
Re-Wheeling An NG/G16
NG/G16 129 Engine Unit Frames Near Completion
Another New Boiler For Puffing Billy!
Sustaining The Operation
NG/G16 129 Is Coming Together....Virtually!
First Pictures Of The New NG/G16 Boiler Construction!
NG/G16 Workshop Progress
During 2016, the decision was taken to trial moving the Day Out with Thomas event to Gembrook, starting with the spring season, thus inaugurating Gembrook as the railways new centre of special events.
Locomotives and rolling stock were transferred in the Down direction on a Friday evening, and back again on Sunday evening at the conclusion of the weekends shows. Peckett No. 1711, which usually masquerades as the cheeky blue tank engine, began to suffer from the extra mileage; overheating bearings on the rear axle being the problem.
Sadly Thomas’ arthritis continued to play up, despite the workshops continued efforts to cure it. At his lowest point, he was lifted onto a tilt tray and trucked from Belgrave to Gembrook, where he was only able to trundle around the yard and pose for photos with his many visiting admirers.
If dropping wheelsets out of a locomotive was an Olympic sport, the Belgrave workshop team would have it in the bag; the brake rigging, motion, valve gear and wheelsets were being removed and replaced 3 or 4 times in a week while measurements were taken and rectification work carried out.
The problem was bought under control so that the autumn season could be completed, at which point the decision was taken that Thomas would spend Christmas at Belgrave undergoing a ‘D’ exam.
On top of the usual tasks involved in this level of exam, the wheelsets were removed, and following detailed measurements, machining of the axleboxes and horns was carried out to rectify some misalignment which would have been a contributory factor to the overheating.
Above, Pistons and Crossheads have been cleaned and crack tested, and below, the Slidebars, Connecting rods and Coupling rods have all undergone the same treatment, and await reassembly to the locomotive.
After all parts of the motion had been cleaned, degreased and crack tested, they were given a fresh coat of red paint before refitting.
With everything cleaned, tested, painted and reassembled, 1711 was steamed for a test run back to Emerald.
Following a successful run to Menzies Creek light engine, an NAL carriage (a dining car, originally from the Mount Lyell Railway in Tasmania) was coupled up, as it was destined to undergo maintenance at the Emerald Carriage Workshop.
The engine steamed well up the notorious Emerald bank, suffering no overheating issues, and with an improved lubrication regime, the Autumn Thomas season presented no further issues.
For the future, a CAPEX for an increased capacity mechanical lubricator has been approved, which will allow for forced lubrication of the axlebox crowns, reducing the chance of further hot-boxes being caused by a lack of sufficient lubrication.
This article first appeared on puffingbillyworkshops.blogspot.com
About this website
Railpage version 3.10.0.0037
All logos and trademarks in this site are property of their respective owner. The comments are property of their posters, all the rest is © 2003-2020 Interactive Omnimedia Pty Ltd.
You can syndicate our news using one of the RSS feeds.