A New Smokebox Door Seal For 6A
Re-Wheeling An NG/G16
NG/G16 129 Engine Unit Frames Near Completion
Another New Boiler For Puffing Billy!
Sustaining The Operation
NG/G16 129 Is Coming Together....Virtually!
First Pictures Of The New NG/G16 Boiler Construction!
NG/G16 Workshop Progress
August 2015....Belgrave workshops. The occasion? Re-uniting the first of the NG/G16 engine units with it's driving wheels. Of course these things don't just happen, and the event was preceded with much machining and fitting work.
All the slippers and wedges - which align the axleboxes in the frames - had to be re-machined to suit the thickness of the frames. The frames had been built up and re-machined to eliminate the results of years of wear in service. Both the slippers and wedges have been shimmed from the frames to create the correct opening width for the axleboxes, and all new retaining and adjusting bolts have been manufactured.
All the axleboxes have been fitted with their Vesconite hub liners, and the overall width of the boxes machined to suit the distance between the wheel hub face and the crank, including the correct clearance. Above, the fit of one of the axleboxes is being checked.
Below, the top of an axlebox is visible, showing the slots machined to accept the spring saddles, and the original oil wells which fed the bearing and the slide faces. We won't be making use of these as the cellar oil pads for the bearing surfaces will be filled from underneath using quick release couplings, as with all other PBR locomotives. The slide faces will be fed through flexible hoses from oil pots mounted on the engine unit frames.
Above, the axleboxes have been fitted to their respective axle journals, and the wheelsets suitably spaced ready to receive the frames.
Below, the frame site on its wheels over the workshop pit. No suspension has been fitted at this stage; the frames are are spaced off the top of the axleboxes using packing blocks at this stage.
The last photograph shows some of the suspension being trial fitted, including the pony truck spring and the compensating beam below the cylinder. The cylinder rear covers have been bolted on as well, to test fit the slidebars before they are sent for grinding.
The steel angle sections running behind the cylinders from the headstock to the slide bar bracket is the tank support frame, to which the water tanks are bolted.
This article first appeared on puffingbillyworkshops.blogspot.com
About this website
Railpage version 3.10.0.0037
All logos and trademarks in this site are property of their respective owner. The comments are property of their posters, all the rest is © 2003-2022 Interactive Omnimedia Pty Ltd.
You can syndicate our news using one of the RSS feeds.